By clicking the top sliding row of thumbnails you will be shown a sample collection of the many accessories and attachments available to compliment our range of Studwelding Equipment.

Accessories have been developed to assist our customers maximise their use of studwelding.

Our Sales Team will be pleased to discuss available options to help you overcome any production line jigging or locating issues.

The Heavy Duty Front End Cap, also shown with Tri-Pod Legs. The 30mm NoseCone, with various length spacers, can be added allowing use of jigging. The Extension Leg Assembly is mainly for use with longer studs or nails.

Or Sales Team will be pleased to help and assist with queries you may have with regard to our range of accessories......

---------------------------------------------------------

On display are a wide selection of "Chucks", often called collets or studholders, for various models and manufacture of CD Equipment. Also shown is a CD Chuck Centre Jig. and Chucks doe Drawn Arc Equipment.

Or Sales Team will be pleased to help and assist with queries you may have with regard to our range of accessories......

The nozzles are for use with a bending bar. Used to test weld integrity by controlled bend angle. A split section front end cap for use with small diameter jigs. The Off-Set Chuck Adaptor allows welding close to upright panel or inside boxes. A collection of panel and cable plugs and sockets. Mis-use will damage these components.

Or Sales Team will be pleased to help and assist with queries you may have with regard to our range of accessories......

Examples of alternate version of FEC assembles etc,.

Or Sales Team will be pleased to help and assist with queries you may have with regard to our range of accessories......

Plugs & Sockets......

Will burn out if not properly tightened.
Weld energy is lost and poor welds will result.
Condition should be checked regularly and items replaced if signs of burning are evident.

Chucks.. fit into the handtool and hold the weld stud during the welding process. Grip on the stud is maintained by a metal clip or rubber ring.
Chucks are supplied complete with an adjustable backstop.

NOSE CONE ASSEMBLIES:
..are used to accurately locate studs when using templates. These are available in 3 diameters: 30mm (standard), 1" and 22mm. Nose cones can be cut to fit around complex shapes or manufactured with extended "chimney" to locate inside high sided narrow components such as deep channels or - to totally enclose the weld area for noise reduction.

Which Process
for you?

Capacitor Discharge

Short Cycle

Drawn Arc